Programming 
 
    INC: Increase Volume 

    FUNC: Function. Stores the data when the single or dual gate is chosen. The digital display will show P2.

    DEC: Decrease Value 

    LEARN: Learn (remotes, keypads, etc.) 
 
Programming Guide 
 
    P1: When set to 01 the gate is set for single actuator. 11 is set for dual actuators. 

    P2: Indicates which side (left or right) is the master actuator. It will be the first actuator to receive a signal. 

    P3: The interval between the master and slave actuators for the gate opening. "0" - "9" seconds. 
    The open interval can be chosen by pressing the INC and DEC buttons.

    P4: The interval between the master and slave actuators for the gate closing. "0" - "9" seconds.
    The closing interval can be chosen by pressing the INC and DEC buttons.

    P5: Indicates that the gate opener is on Stall Force Adjustment.
    The Stall Force is adjusted by pressing INC and DEC buttons. The options are "1" - "9".
    Press FUNC to store the data for Gate Opener 1.

    P6: You can adjust the force of Gate Opener 2.

    P7: You can adjust the MRT (Max Motor Running Time) of Motor 1. The options are "1" - "50" seconds.
    The MRT is adjusted by pressing INC and DEC buttons.
    Press FUNC to store the data for Motor 1.

    P8: You can adjust the MRT of Motor 2.
    The MRT is adjusted by pressing INC and DEC buttons.
    Press FUNC to store the data for Motor 2.

    P9: The gate opener is now in PBS (Photocell Beam System) mode.
    To set the PBS function you can pressed and release the INC or DEC buttons.
    When the digital display shows 11, the PBS is available. The it indicates 00, the PBS is off.
    Press the FUNC button to store the data.

    PA: The gate opener is now in the settings for the automated closing time mode. The time is adjusted by             pressing the INC and DEC buttons. The display will read "01" - "99", which indicates the seconds. When the     display reads as "00", the automatic closing time is shut off.
    Press the FUNC button to store the data.

    PB: The gate opener is in the settings for soft start. Press and release the INC and DEC buttons to adjust the       settings. The soft start period is "1" - "9" seconds.

    PD: Press and release the INC and DEC buttons, and all data will then return to factory settings.